How can I get Active@ Disk Image to recognize my LaCie D2 Ethernet Storage device which is plugged into my local network?

To address the issue, please ensure the LaCie Network Assistant is installed on you computer.

Follow LaCie's instructions for setting up the network device, using the LaCie Network Assistant Here is information about the LaCie D2 Ethernet Network Attached Storage (NAS) device and how to map a network drive. This will allow Active@ Disk Image to save images to the NAS device: http://www.lacie.com/support/support_manifest.htm?id=10476&article=1146

You are advised that storing your Active@ Disk Images on a NAS device may result in the inability to restore an image if a system failure occurs. The reason for this is that our Boot Environment may not recognize the NAS device upon boot-up. Drivers for the NAS device may be required, and can be loaded, so the boot environment can recognize the NAS device. Ensure you can boot from the Active@ Disk Image boot CD/USB media and confirm you can access the NAS device.